Engineering · 04 · Build
Manufacturing & Assembly
Prototype to production, SMT and through-hole, with sourcing and quality systems in the same engagement.
What it is
Prototype fabrication on a turn that lets design iterate, and production runs that hold the same quality from the first hundred boards to the ten-thousandth. Both motions run through the same engineering team, so the design notes don't get lost at the handoff to fab.
Sourcing, inventory, and JIT delivery are part of the service — not a separate vendor the customer has to manage. Quality systems and traceability are built in so audits, recalls, and regulated industries are practical, not painful.
Capabilities
- Fabrication
- Quick-turn prototypes
- Production manufacturing — low to high volume
- Multilayer, HDI, flex, rigid-flex
- Assembly
- Surface-mount (SMT) assembly
- Through-hole assembly
- Box build and final assembly
- Sourcing & logistics
- Component sourcing and procurement
- Inventory management and JIT delivery
- Turnkey services across design, fab, and assembly
- Quality
- DFM analysis pre-build
- Inspection and testing programs
- Full traceability for regulated industries
Often paired with
Hardware Engineering
Board-level design for systems where signal integrity, power, and thermals are non-negotiable.
Firmware & Embedded Systems
Bare-metal and RTOS firmware on ARM, RISC-V, and Espressif — from board bring-up to OTA.
PCB Design & Layout
Two to seventy-six layers, including HDI, flex, rigid-flex, and high-speed — with SI/PI built into the routing, not bolted on at the end.